LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Engine Mechanical - 6.6L (On-Vehicle)) >> Removal & Installation >> Exhaust Manifold >> Removal (Left)

Removal (Left)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support vehicle. Remove exhaust pipe heat shield bolts. Reposition heat shield to side in order to access exhaust pipe to exhaust manifold bolts.
  2. Remove exhaust pipe to exhaust manifold bolts. Lower vehicle in order to work through front wheelhouse opening. Remove wheelhouse panel.
  3. Remove front tire and wheel. Remove charged air cooler outlet duct.
  4. Remove exhaust manifold heat shield bolts. Remove exhaust manifold heat shield. Remove exhaust manifold bolts/nuts. Remove exhaust manifold. Remove manifold from rear stud. Remove manifold from front stud. Slide manifold out bottom, past oil filter.
  5. Remove and discard exhaust manifold gasket. Clean and inspect exhaust manifold.
scientia non olet · About LEMON Manuals