LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 649 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Center Pillar >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the center pillar trim panel and spoon the weatherstrip flipper over the trim edge, push in on the trim panel in order to secure the clips.
  2. Install the front carpet retainers. Refer to Carpet Retainer Replacement - Front  .
  3. Install the rear carpet retainer. Refer to Carpet Retainer Replacement  .
  4. Enable the SIR system. Refer to ACTIVATING SYSTEM .
    Fig 1: Installing Center Trim Panel
    G01803983Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals