LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 645 (Wiring Systems (General Information)) >> Diagnostic Information And Procedures >> Pull to Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair pull-to-seat connectors.

  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves.
  3. Using the proper pick or removal tool insert into the front of the connector body.
  4. Grasp the wire at the back of the connector body and gently pull the terminal (1) from the connector body (3).
  5. Inspect the terminal for damage, if damaged refer to Terminal Repair.
  6. Reform the locking tang (2) if the terminal is being reused.
    7. Fig 1: Removing Terminal
    G01802744Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals