LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 642 (Body Rear End) >> Repair Instructions >> Fuel Filler Pocket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel filler pocket to the fuel filer neck.
    2. Fig 1: Identifying Fuel Filler Pocket
    G01756346Courtesy of GENERAL MOTORS CORP.
  2. Press in until the fuel filler pocket is fully seated to the quarter panel.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the bolts. Tighten the fuel filler neck bolts to 5 N.m (44 lb in).
    Fig 2: Identifying Fuel Filler Pocket Bolts
    G01756347Courtesy of GENERAL MOTORS CORP.
  4. Remove all tape from fuel filler pocket opening.
  5. Replace the fuel filler cap.
  6. Close the fuel filler door.
scientia non olet · About LEMON Manuals