LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Servicing - A/T (AF33-5)) >> Removal & Installation >> Transaxle Range Switch >> Removal

Transaxle Range Switch: Removal

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: DO NOT tip battery over 45 degree angle or acid could spill.
NOTE: Record all pre-set radio stations prior to disconnecting battery and reprogram pre-set stations after repair.
  1. Remove battery cover. Disconnect negative battery cable. Disconnect positive battery cable. Loosen battery hold-down screw and remove battery. See Figure .
  2. Remove battery cooling box. See BATTERY COOLING BOX  . Remove battery tray bracket. Loosen battery tray bracket screws and remove bracket. See Figure .
  3. Apply parking brake and place control shift lever in Neutral position. Using Fascia Retainer Remover (J36346) remove control cable assembly from transaxle range switch lever.
  4. Disconnect harness connectors from transaxle range switch. Remove transaxle range switch lever nut and lever. Using a screwdriver, bend lock washer tabs on manual shaft nut retainer down. Remove nut, lock tab washer and flat washer. Remove transaxle range switch bolt stud and flat washers. Remove transaxle range switch.
Fig 1: Removing & Installing Transaxle Range Switch Nut
G00078164Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals