LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Servicing - A/T (AF33-5)) >> Removal & Installation >> Control Valve Body Cover >> Installation

Control Valve Body Cover: Installation

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Saturn ATF (P/N 21005966 and 21019223), and DEXRON-III ATF are not compatible with this transaxle. This transaxle uses T-IV Fluid (P/N 22689186) only.
  1. Clean any gasket material from valve body cover and inspect gasket mounting surface. Install valve body cover onto transaxle case using new bolts and washers. See Figure .
  2. Tighten valve body cover bolts to specification in sequence shown. See Figure . See TORQUE SPECIFICATIONS  . Install transaxle oil cooler line assembly to transaxle.
  3. Install transaxle oil cooler line assembly nut. See Figure . Torque transaxle oil cooler line nut to specification. Install front pitch restrictor and through bolt. See Figure . Torque front pitch restrictor through bolt to specification. See TORQUE SPECIFICATIONS  .
  4. Install front pitch restrictor-to-transaxle bolts. See Figure . Torque front pitch restrictor bolts to specification. See TORQUE SPECIFICATIONS  . Install left-hand splash shield. See Figure .
  5. Install left wheel and tire assembly. Install wheel nuts and tighten in a criss-cross pattern. Torque wheel nuts to specification. See TORQUE SPECIFICATIONS  .
  6. Lower vehicle. Add fluid to transaxle. See DRAINING & REFILLING  .
scientia non olet · About LEMON Manuals