Crankshaft Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Install the crankshaft sprocket drive pin (1).

Fig 1: Installing Crankshaft Sprocket Drive Pin
Courtesy of GENERAL MOTORS CORP.
Ensure pin height (1) is 1.75-3.25 mm (0.0689-0.1280 in).

Fig 2: Identifying Pin Height
Courtesy of GENERAL MOTORS CORP.
Gently lower the crankshaft into position in the cylinder block.
Make sure the crankshaft turns without binding or noise.

Fig 3: Installing Crankshaft
Courtesy of GENERAL MOTORS CORP.