Tools Required

J 36660-A  Torque Angle Meter

1. Ensure that the right secondary timing chain tensioner (1) is being installed.
   Fig 1: Checking For Right Secondary Timing Chain Tensioner Installation

   Courtesy of GENERAL MOTORS CORP.
2. Compress the right secondary timing chain tensioner shoes with your hand.
3. Lock the right secondary timing chain tensioner by inserting a piece of wire (2) into the access hole in the side of the right secondary timing chain tensioner (1).
4. Slowly release pressure on the right secondary timing chain tensioner shoes. The right secondary timing chain tensioner should remain compressed.
   Fig 2: Locking Right Secondary Timing Chain Tensioner

   Courtesy of GENERAL MOTORS CORP.
5. Position the secondary timing chain tensioner between the camshafts.
   CAUTION: Refer to in FASTENER NOTICE .
6. Install the secondary timing chain tensioner bolts.

   Tighten 

   Tighten the secondary timing chain tensioner bolts to 12 N.m (106 in lbs).

   Fig 3: Installing Secondary Timing Chain Tensioner

   Courtesy of GENERAL MOTORS CORP.
7. Wrap the secondary timing chain around both secondary drive sprockets.
8. Align the intake sprocket drive pin (1) between the two darkened links (2).
9. Align the exhaust sprocket drive pin (4) with the single darkened link (3).
   Fig 4: Aligning Exhaust & Intake Sprocket Drive Pins

   Courtesy of GENERAL MOTORS CORP.
10. Fit the intake and exhaust camshaft sprockets with the secondary timing chain onto their respective camshafts and align the drive pins in the camshafts.
11. Install the camshaft sprocket bolts.

    Tighten 

    1. 11.1. Tighten the camshaft sprocket bolts to 25 N.m (18 ft lbs).
    2. 11.2. Tighten the camshaft sprocket bolts an additional 45 degrees using the J 36660-A. 
12. Remove the locking wire from the secondary timing chain tensioner allowing the tensioner shoes to expand and apply pressure to the timing chain.
    Fig 5: Installing Camshaft Sprocket Bolts

    Courtesy of GENERAL MOTORS CORP.