LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 637 (Engine Mechanical - 3.5L (Unit Repair)) >> Repair Instructions >> Ignition Module Installation - Right (w/o RPO NC1)

Ignition Module Installation - Right (w/o RPO NC1)

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press the spark plug boots onto the ignition coil assembly.
    Fig 1: Installing spark Plug Boots
    G01815514Courtesy of GENERAL MOTORS CORP.
  2. Lower the ignition coil assembly into the camshaft cover valley. DO NOT damage the ignition coil assembly's perimeter seal.
    CAUTION: Refer to in FASTENER NOTICE .
  3. Install the ignition coil assembly bolts.

    Tighten 

    Tighten the ignition coil assembly bolts to 9 N.m (80 in lbs).

    Fig 2: Installing Ignition Coil Assembly
    G01815515Courtesy of GENERAL MOTORS CORP.
  4. Install the fuel injector sight shield bracket.
  5. Install the fuel injector sight shield bracket bolts.

    Tighten 

    Tighten the fuel injector sight shield bracket bolts to 8 N.m (71 in lbs).

    Fig 3: Installing Fuel Injector Sight Shield Bracket
    G01815516Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals