LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 636 (Rear Wheel Steering System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the steering knuckle (2) to the vehicle.
  2. Install the upper ball joint. Refer to Upper Ball Joint Replacement .
  3. Install the lower ball joint. Refer to Lower Ball Joint Replacement .
  4. Install the park brake cable retaining bolt (3) to the steering knuckle. Tighten the bolt to 65 N.m (48 ft lbs).
  5. Install the wheel hub and bearing. Refer to Wheel Hub & Bearing Replacement .
  6. Install the outer tie rod retaining nut to the steering knuckle. Tighten the nut to 55 N.m (40 ft lbs).
  7. Install the outer tie rod retaining bracket (2). Tighten the bracket to 65 N.m (48 ft lbs).
  8. Install the tire and wheel.
  9. Lower the vehicle.
  10. Perform a four wheel alignment. Refer to SPECIFICATIONS .
scientia non olet · About LEMON Manuals