LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 636 (Rear Wheel Steering System) >> Repair Instructions >> Steering Gear Motor Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Make sure the O-ring is seated in the O-ring groove.

  1. Install the O-ring seal (1) to the steering gear.
  2. Install the steering gear motor (2) to the vehicle.
  3. Install the bolts (1) retaining the steering gear motor (2) to the steering gear. Tighten the 6 mm (0.24 in) steering gear motor retaining bolts to 10 N.m (89 in lbs). Tighten the 4 mm (0.16 in) steering gear motor retaining bolts to 4 N.m (35 in lbs).

    Important:  Route the wiring harness in the same location as the wiring was removed.

  4. Connect the electrical connectors to the control module (2).
  5. Connect the electrical connector (1) to the rear position sensor.
  6. Connect the wire harness retaining clips.
  7. Install the spare tire to the vehicle.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals