LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 636 (Rear Wheel Steering System) >> Repair Instructions >> Rear Wheel Steering Tie Rod End Replacement - Inner >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle.
  2. Remove the tire and wheel.
  3. Remove the rack and pinion boot from the steering gear. Refer to Rack & Pinion Boot Replacement .

    Important:  The inner tie rod support clamp has right h and threads. The inner tie rod support nut has left h and threads. To remove the support clamp turn the clamp counterclockwise.

  4. Using the J 44665-1  (1) and J 44665-2  (2) remove the inner tie rod support clamp.
    5. Fig 1: Removing Inner Tie Rod Support Clamp
    G01667472Courtesy of GENERAL MOTORS CORP.
  5. Remove the inner tie rod (1) from the steering gear using the J 44665-2  (2).
    Fig 2: Removing Inner Tie Rod
    G01667473Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals