LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 636 (Rear Wheel Steering System) >> Repair Instructions >> Lower Ball Joint Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower ball joint (2) to the vehicle.
  2. Install the bolts (2) retaining the lower ball joint (3) to the steering knuckle. Tighten the bolts to 110 N.m (81 ft lbs).
  3. Install the lower ball joint pinch bolt (1). Tighten the bolt to 230 N.m (169 ft lbs).
  4. Install the snap ring (2) to the lower ball joint.
  5. Install the bolt (8) and nut (2) retaining the bracket to the axle. Tighten the retaining bolt and nut to 25 N.m (18 ft lbs).
  6. Install the tire and wheel.
  7. Lower the vehicle.
  8. Perform a four wheel alignment. Refer to SPECIFICATIONS .
scientia non olet · About LEMON Manuals