LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 635 (Steering Wheel And Steering Column) >> Repair Instructions >> Turn Signal Switch Housing - Assemble - Off Vehicle (Tilt)

Turn Signal Switch Housing - Assemble - Off Vehicle (Tilt)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The switch mounting bracket must be pressed firmly against the steering column tilt head.

  1. Slide the turn signal switch housing onto the steering column shaft assembly.
  2. Install the turn signal and multifunction switch assembly only. Refer to Turn Signal & Multifunction Switch Assembly - Assemble - Off Vehicle .
  3. Install the steering column tilt head components. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle .
  4. Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals