LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 635 (Steering Wheel And Steering Column) >> Repair Instructions >> Turn Signal Cancel Cam & Bearing Thrust Washer - Assemble - Off Vehicle >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the following parts onto the steering shaft assembly:
    1. 1.1. The thrust washer (1).
    2. 1.2. The upper bearing spring (2).
  2. Lubricate the turn signal cancel cam assembly (3) with lithium grease.
  3. Install the turn signal cancel cam assembly (3) onto the steering shaft assembly.
  4. Install the cam orientation plate (4) onto the steering shaft assembly.
  5. Install the new bearing retainer onto the steering shaft assembly.
  6. Compress the cam orientation plate using J 23653-SIR  and J 42137  .
  7. Firmly seat the bearing retainer into the groove on the steering shaft assembly.
  8. Remove the J 23653-SIR  .
  9. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil - Disassemble - Off Vehicle .
  10. Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals