LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 635 (Steering Wheel And Steering Column) >> Repair Instructions >> Shift Lever Replacement - On Vehicle (With Tow/Haul Switch) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift lever (1).
  2. Connect the shifter electrical connector.
  3. Install the wire straps to the harness.
  4. Install the harness retaining pin (4) to the instrument panel.
  5. Install the knee bolster deflector bracket and nuts (1). Tighten the nuts to 9 N.m (80 lb in).
  6. Install the knee bolster.
  7. Install the TORX® head screw. Tighten the screw to 1.5 N.m (13 lb in).
  8. Roll the seal over the TORX® head screw.
  9. Install the lower column cover.
  10. Install the 2 TORX head screws to the lower column cover. Tighten the screw to 3.5 N.m (31 lb in).
scientia non olet · About LEMON Manuals