LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 635 (Steering Wheel And Steering Column) >> Repair Instructions >> Multifunction, Turn Signal & Hazard Switch Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the multifunction turn signal/hazard switch to the steering column.
  2. Install the screws retaining the multifunction switch to the steering column. Tighten the screws to 6 N.m (53 lb in).
  3. Connect the park position switch electrical connection.
  4. Install the wire harness straps to the steering column wire harness (1).
  5. Install the gray and black wiring harness connectors (1) to the column bulkhead connector.
  6. Connect the automatic transmission shift lock control electrical connector.
  7. Install the steering column bulkhead connector to the vehicle wire harness. Tighten the center screw to 6 N.m (53 lb in).
  8. Install the wire straps on the steering column wire harness.
  9. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  10. Tighten the steering column bracket nuts. Tighten the nuts to 30 N.m (22 lb ft).
  11. Install the knee bolster.
  12. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals