LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 635 (Steering Wheel And Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement - Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  If you are installing the same shaft, align the marks and the relationship of the bolt and the clamp made during the removal procedure.

  1. Install the lower end of the upper intermediate shaft through the bulkhead, into the lower shaft.
  2. Install the upper end of the upper intermediate shaft (2) to the steering column.
  3. Install the bolt and the nut (1) at the connection of the upper intermediate shaft to the steering column. Tighten the nut to 47 N.m (35 lb ft).
  4. Install the accelerator pedal position sensor, if equipped. Refer to the following procedures:
  5. Install the bolt and nut at the connection of the upper intermediate shaft to the lower intermediate shaft. Tighten the nut to 47 N.m (35 lb ft).
  6. Remove the J 42640  from the steering column lower access hole.
scientia non olet · About LEMON Manuals