LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 634 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Steering Damper Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the steering damper (4).
  2. Install the mounting bolt (5) and a new prevailing torque nut (6).
  3. Install the steering damper ball stud (2) to the relay rod (3).
  4. Install the J 29193  .
  5. Tighten the steering linkage installer in order to seat the stud in the relay rod. Tighten the installer to 54 N.m (40 ft lbs).
  6. Remove the J 29193  .
  7. Install the prevailing torque nuts. Tighten the mounting nut to 40 N.m (30 ft lbs). Tighten the ball stud nut to 40 N.m (30 ft lbs).
  8. Install the engine protection shield, if equipped.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals