Disassembly Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

To remove the outer tie rod. Refer to Tie Rod End Replacement - Outer .
Remove the hexagon jam nut (2) from the inner tie rod assembly (1).

Fig 1: Inner Tie Rod Assembly Hexagon Jam Nut
Courtesy of GENERAL MOTORS CORP.
Remove the tie rod end clamp (2) from the rack and pinion boot (1).

Fig 2: Rack & Pinion Boot
Courtesy of GENERAL MOTORS CORP.
Remove the boot clamp (1) from the rack and pinion boot with side cutters.
Discard the boot clamp (1).
Important: If a breather tube is present, mark the location of the breather tube on the gear assembly before removal of the rack and pinion boot.
Remove the rack and pinion boot (1) and the breather tube, if present, from the rack and pinion gear assembly.