LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 633 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (Without Hydro-Boost) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering cooler (1) to the vehicle. Tighten the power steering cooler retaining bolts to 5 N.m (44 in lbs).
  2. Connect the power steering outlet hose (3) to the power steering gear (4). Install the retaining clamp.
  3. Connect the power steering inlet hose to the power steering pump. Install the retaining clamp.
  4. Bleed the power steering system. Refer to Bleeding Power Steering System .
  5. Inspect all the hose connections for leaks.
  6. Install the front grille.
scientia non olet · About LEMON Manuals