LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 633 (Power Steering System) >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the hose in the same position the hose occupied prior to removal.
  2. Install the brake booster inlet hose (1) to the brake booster (2).
  3. Install the brake booster inlet hose to the power steering pump. Tighten the brake booster inlet hose fittings to 27 N.m (20 ft lbs).
  4. Remove the drain pan from under the vehicle.
  5. Bleed the power steering system. Refer to Bleeding Power Steering System .
scientia non olet · About LEMON Manuals