Checking & Adding Power Steering Fluid (W/O Hydro-Boost)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks.

Clean the area surrounding the reservoir cap
Remove the reservoir cap.
Inspect the power steering pump fluid level at regular intervals. Use the appropriate procedure below. Add fluid when required.
Fluid Is Cold
1. 3.1. Remove the reservoir cap.
2. 3.2. Inspect the fluid level on the cap stick
3. 3.3. Ensure that the fluid level is between the bottom of the COLD/FULL mark and the end of the cap stick.
Fluid Is Hot
1. 3.1. Run the engine until the fluid reaches about 80°C (170°F).
2. 3.2. Turn the engine OFF.
3. 3.3. Remove the reservoir cap.
4. 3.4. Inspect the fluid level on the cap stick
5. 3.5. Ensure that the fluid level is between the HOT/FULL and the COLD/FULL marks on the cap stick.
If the fluid level is low, add power steering fluid to the proper level.
Install the reservoir cap.
When checking the fluid level after servicing the steering system, bleed the air from the system. Refer to Bleeding Power Steering System .