LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 629 (Power Steering System) >> Repair Instructions >> Tie Rod End Replacement - Outer >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).
    Fig 1: Installing Outer Tie Rod To Inner Tie Rod
    G01581745Courtesy of GENERAL MOTORS CORP.
  2. Install the outer tie rod (1) to the steering knuckle (2).
    Fig 2: Installing Outer Tie Rod To Steering Knuckle
    G01581746Courtesy of GENERAL MOTORS CORP.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the outer tie rod retaining nut (3).

    Tighten 

    Tighten the outer tie rod retaining nut to 30 N.m (22 ft lbs) plus an additional 180 degrees.

  4. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  5. Lower vehicle.
  6. Adjust the toe alignment. Refer to FRONT TOE ADJUSTMENT in Wheel Alignment.
    Fig 3: Install Outer Tie Rod Retaining Nut
    G01581747Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals