LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Cancel Cam & Steering Shaft Upper Bearing Spring Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the inner race (1) with synthetic grease.
  2. Install the inner race (1) onto the steering shaft.
  3. Install the upper bearing inner race seat (2) onto the steering shaft.
  4. Install the upper bearing spring (3) onto the steering shaft.
  5. Lubricate the lower brass surface of the turn signal cancel cam (4) with synthetic grease.
  6. Install the turn signal cancel cam (4) onto the steering shaft.
  7. Install the shaft lock shield (5) onto the steering shaft.
    Fig 1: Shaft Lock Shield
    G01571835Courtesy of GENERAL MOTORS CORP.
  8. Compress the shaft lock shield (2) using J 23653-SIR  and J 42137  .
  9. Install the new bearing retainer (1) onto the steering shaft.
  10. Firmly seat the bearing retainer (1) into the groove on the steering shaft.
  11. Remove J 23653-SIR  and J 42137  from the steering shaft.
  12. Install the wave washer (1) onto the steering shaft (2).
  13. Install the SIR coil.
  14. Install the steering wheel. Refer to Steering Wheel Replacement .
  15. Install the inflator module.
  16. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  17. Connect the battery negative cable.
scientia non olet · About LEMON Manuals