LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering wheel on the steering column.
  2. Route the SIR connector through the steering wheel.
  3. Align the scribe mark on the steering wheel with the slash mark on the steering shaft.
  4. Install the steering wheel.
  5. Install the steering shaft nut. Tighten the steering shaft nut to 45 N.m (33 ft lbs).
  6. Install the inflatable restraint steering wheel module. Refer to AIR BAG MODULES .
  7. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  8. Inspect the operation of the following components:
    • The horn
    • The steering wheel
    • The steering wheel controls
scientia non olet · About LEMON Manuals