LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction Turn Signal Lever Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the multifunction turn signal lever (2). Use a small flat-blade in order to compress the electrical contact and move the multifunction turn signal lever into position.
  2. Verify that the electrical contact rests on the canceling cam.
  3. Install the retaining bolts to the multifunction turn signal lever. Tighten the retaining bolts to 7 N.m (62 in lbs).
  4. Connect the gray and black connectors to the multifunction turn signal lever steering column bulkhead connector.
  5. Connect the steering column bulkhead connector to the vehicle wire harness.
  6. Install the two wire harness straps to the steering column wire harness (1).
    7. Fig 1: Steering Column Wire Harness
    G01571841Courtesy of GENERAL MOTORS CORP.
  7. Install the steering column wire harness (1) to the steering column wire harness retainer (2).
  8. Install the steering column knee bolster.
  9. Install the steering column trim cover. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  10. Verify that the lever is in the center or the OFF position.
  11. Install the steering wheel to the steering column. Refer to Steering Wheel Replacement .
  12. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  13. Connect the negative battery cable.
scientia non olet · About LEMON Manuals