LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Steering Wheel & Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the intermediate steering shaft into place.
  2. Install the upper pinch bolt which secures the intermediate steering shaft to the steering column. Tighten the pinch bolt to 48 N.m (35 ft lbs).
  3. Install the intermediate steering shaft seal onto the steering column.
  4. Raise and support the vehicle.
  5. Install the intermediate steering shaft (1) to the power steering gear stub shaft (2).
  6. Install the lower pinch bolt which secures the intermediate steering shaft to the power steering gear stub shaft. Tighten the pinch bolt to 48 N.m (35 ft lbs).
  7. Remove the J 42640  from the steering column.
  8. Install the intermediate steering shaft seal onto the power steering gear.
  9. Install the tire and wheel assembly.
  10. Lower the vehicle.
  11. Install the left instrument panel insulator.
scientia non olet · About LEMON Manuals