LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Steering Wheel & Steering Column) >> Repair Instructions >> Automatic Transmission Shift Lock Control - Assemble - Off Vehicle

Automatic Transmission Shift Lock Control - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the automatic transmission shift lock control.
  2. Put the column in the NEUTRAL position.
    Fig 1: Shift Lock Control
    G01571897Courtesy of GENERAL MOTORS CORP.
  3. Adjust the automatic transmission shift lock control by performing the following steps:
    1. Pull the tab (1) out on the block side of the automatic transmission shift lock control.
    2. Press on the adjuster block (2) to compress the internal adjuster spring to disengage the adjuster teeth. Slide the adjuster block as far away from the solenoid as possible.
    3. Lock in place by pushing the tab back in.
    4. Fig 2: Adjuster Block
    G01571898Courtesy of GENERAL MOTORS CORP.
  4. Inspect the automatic transmission shift lock control by performing the following steps:
    1. The automatic transmission shift lock control must lock the gear shift lever when it is put into the PARK position.
    2. When the column is installed in the vehicle you will not be able to shift the gear shift lever out of the PARK position without pressing on the brake pedal. The solenoid will be energized.
    3. Readjust if needed.
  5. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
  6. Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals