Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required:

J 23653-SIR Steering Column Lock Plate Compressor
J 42137 Steering Column Lock Plate Compressor Adapter

Install the following parts onto the steering shaft assembly:
1. The thrust washer (1).
2. The upper bearing spring (2).
3. Lubricate the turn signal cancel cam assembly with lithium grease.
4. The turn signal cancel can assembly (3).
5. The shaft lock shield assembly (4).
Fig 1: Installing Steering Shaft Assembly Components
Courtesy of GENERAL MOTORS CORP.
Compress the shaft lock shield assembly using J 23653-SIR and J 42137 .
Install the new bearing retainer (1) onto the steering shaft assembly.
Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
Remove J 23653-SIR and J 42137 from the steering shaft assembly.
WARNING: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
Install the inflatable restraint steering wheel module coil assembly. Refer to Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle .
Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM .

Fig 2: Installing New Bearing Retainer
Courtesy of GENERAL MOTORS CORP.