LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 621 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Lock Cylinder Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert the ignition lock cylinder through the upper shroud.
  2. Install the ignition lock cylinder to the lock module assembly by doing the following procedures:
    1. Align the positioning slot and locking tab slot on the lock module assembly to the positioning tab and locking tab on the ignition lock cylinder.
    2. Push the ignition lock cylinder into the lock module assembly until the locking tab locks against the locking tab.
  3. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  4. Install the shift lever seal to the upper and the lower shrouds.
    Fig 1: Installing Shift Lever Seal
    G01687877Courtesy of GENERAL MOTORS CORP.
  5. Install the steering wheel. Refer to Steering Wheel Replacement .
  6. Install the tilt wheel lever. Refer to Tilt Lever Replacement - On Vehicle .
  7. Enable the SIR system. Refer to ACTIVATING SYSTEM .
  8. Perform the Passlock learn procedure. Refer to PROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS .
scientia non olet · About LEMON Manuals