LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 618 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Weather Pack Connectors

Weather Pack Connectors

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

The following is the proper procedure for the repair of Weather Pack(R) Connectors.

  1. Separate the connector halves (1).
  2. Open the secondary lock. A secondary lock aids in terminal retention and is usually molded to the connector (1).
  3. Grasp the wire and push the terminal to the forward most position. Hold the wire in this position.
    Fig 1: Separating Connector Halves
    G01735971Courtesy of GENERAL MOTORS CORP.
  4. Insert the Weather Pack(R) terminal removal tool into the front (mating end) of the connector cavity until it rests on the cavity shoulder (1).
  5. Gently pull on the wire to remove the terminal through the back of the connector (2).

    Important:  Never use force to remove a terminal from a connector.

  6. Inspect the terminal and connector for damage. Repair as necessary. Refer to Repairing Connector Terminals  .
  7. Reform the lock tang (2) and reset terminal in connector body.
  8. Close secondary locks and join connector halves.
  9. Verify that circuit is complete and working satisfactorily.
  10. Perform system check.
    Fig 2: Removing Terminal Through Back Of Connector
    G01735970Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals