LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 618 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Push to Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves (1).
    Fig 1: Separating Connector Halves
    G01735966Courtesy of GENERAL MOTORS CORP.
  3. Use the proper pick or removal tool (1) in order to release the terminal.
  4. Gently pull the cable and the terminal (2) out of the back of the connector.
    Fig 2: Releasing Terminal
    G01735967Courtesy of GENERAL MOTORS CORP.
  5. Re-form the locking device if you are going to reuse the terminal (1).
  6. To repair the terminal, refer to Terminal Repair.
    Fig 3: Re-Forming Locking Device
    G01735968Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals