LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Disc Brakes & Drum Brakes) >> Trouble Shooting >> Disc Brake System >> Front Disc Brake Mounting & Hardware Inspection

Front Disc Brake Mounting & Hardware Inspection

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the disc brake caliper from the caliper mounting bracket. See FRONT BRAKE CALIPER  under REMOVAL & INSTALLATION.
  2. Remove the disc brake pads from the caliper mounting bracket.
  3. Inspect the disc brake pad mounting hardware for the following:
    • Missing mounting hardware.
    • Excessive corrosion.
    • Bent mounting tabs.
    • Looseness at the caliper mounting bracket.
    • Looseness at the disc brake pads.
  4. If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.
  5. Ensure the disc brake pads are held firmly in place on the caliper mounting bracket, yet slide easily on the mounting hardware without binding.
  6. Install the disc brake pads to the caliper mounting bracket.
  7. Install the disc brake caliper to the mounting bracket. See FRONT BRAKE CALIPER  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals