LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Disc Brake Hardware >> Installation

Rear Disc Brake Hardware: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the guide pin bushing in the brake caliper mounting bracket.
  2. Install the brake caliper guide pins.
  3. Apply high temperature silicone brake lubricant to the brake caliper guide pins. DO NOT apply to the brake caliper hardware or the retaining clips.
  4. Install the brake caliper mounting bracket.
  5. Install the brake caliper mounting bolts. Tighten the disc brake caliper mounting bracket bolts. See TORQUE SPECIFICATIONS  .
  6. Install the brake pad retaining clips on the brake caliper mounting bracket.
  7. Install the brake pads to the brake caliper mounting bracket.
  8. Install the brake pad retaining clip to the brake caliper.
  9. Install the brake caliper assembly. See REAR BRAKE CALIPER  .
  10. Install the tire and wheel assembly. Lower the vehicle.
    11. CAUTION: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in personal injury.
  11. Pump the brake pedal slowly and firmly in order to seat the brake pads.
scientia non olet · About LEMON Manuals