LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Removal

Rear Disc Brake Backing Plate: Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Remove the tire and wheel assembly.
  2. Remove the park brake cable from the rear brake caliper. See PARK BRAKE CABLE  .
  3. Remove the brake caliper and bracket assembly. See REAR DISC BRAKE HARDWARE  .
  4. Remove the rear brake rotor.
  5. Remove the park brake shoe.
  6. Remove the rear drive axle. See REAR AXLE SHAFT REPLACEMENT in appropriate REAR DRIVE AXLE article.
  7. Remove the retaining nuts from the backing plate.
  8. Remove the backing plate from the rear axle housing.
scientia non olet · About LEMON Manuals