LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Master Cylinder >> Installation

Master Cylinder: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before installing the master cylinder, bench bleed the master cylinder. See MASTER CYLINDER BENCH BLEEDING  under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
  2. Install the master cylinder assembly.
  3. Install the master cylinder mounting nuts. Tighten the master cylinder mounting nuts. See TORQUE SPECIFICATIONS  .
  4. Connect the brake pipes. See Figure . Tighten the brake pipe fittings. See TORQUE SPECIFICATIONS  .
  5. Connect the master cylinder fluid level sensor connector.
  6. Bleed the hydraulic brakes system. See MANUAL BLEEDING  under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
scientia non olet · About LEMON Manuals