Master Cylinder Fluid Level Sensor: Removal
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the electrical connector from the fluid level sensor.
- Using pair of needle nose pliers, compress the locking tabs (1) for the fluid sensor located at the opposite side of the master cylinder. See Figure .
- Remove the fluid level sensor from the master cylinder reservoir.
NOTE:
When performing the following service procedure, it is NOT necessary to drain the master cylinder reservoir.