LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Front Disc Brake Hardware >> Installation

Front Disc Brake Hardware: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the guide pin bushing on the brake caliper mounting bracket.
  2. Install the guide pins in the brake caliper mounting bracket.
  3. Apply high temperature silicone brake lubricant to the brake caliper guide pins. See Figure . DO NOT apply lubricant to the brake pad hardware or retaining clips.
  4. Install the brake caliper mounting bracket.
  5. Install the brake caliper mounting bracket bolts.
  6. Install the brake pad retaining clips to the brake caliper mounting bracket.
  7. Install the brake pad retaining clip to the brake caliper.
  8. Install the brake caliper assembly. See FRONT BRAKE CALIPER BRACKET  .
  9. Install the tire and wheel assembly. Lower the vehicle.
scientia non olet · About LEMON Manuals