LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Front Brake Caliper >> Removal

Front Brake Caliper: Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Remove the tire and wheel assembly.
  2. Remove the front brake hose bolt. See Fig 1 .
  3. Install a plug in the front brake caliper hose in order to prevent excessive brake fluid loss and contamination.
  4. Discard the metal/copper gaskets. DO NOT reuse them replace with NEW metal/copper gaskets.
  5. Remove the front brake caliper guide pin bolts. See Figure .
  6. Remove the front brake caliper from the mounting bracket.
Fig 1: Identifying Front Brake Hose Bolt
G00307598Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals