LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Disc Brakes & Drum Brakes) >> Overhaul >> Rear Brake Caliper >> Assembly

Rear Brake Caliper: Assembly

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new piston seal, the caliper bore, and the piston with clean brake fluid. See Fig 1 .
  2. Install the piston seal. Make sure the piston seal is not twisted in the caliper bore groove.
  3. Install the boot into the caliper housing bore by hand.
  4. Install the piston in the caliper bore. Push the piston to the bottom of the bore by hand.
  5. Install the boot on the piston.
    Fig 1: Exploded View Of Single Piston Caliper Assembly
    G00083434Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals