Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

In order to protect the body from scratches, use masking tape on the body side edge of the molding. The tape will also help in aligning the molding during installation.

Fig 1: Applying Masking Tape On Body Side

Courtesy of GENERAL MOTORS CORP.

Heat the upper edge of the body side molding to 21-32°C (70-90°F).
- Keep the J 25070 at a distance of 152 mm (6 in) from the surface.
- Use the J 25070 in circulate motion for 30 seconds.
In order to cut the adhesive material, use the J 41409 or a 0.8 mm (0.03 in) plastic line.

Fig 2: Cutting Adhesive Material Using J 41409
Courtesy of GENERAL MOTORS CORP.