LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 606 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Panel Replacement - Knee Bolster >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel cluster trim plate filler. Refer to Filler Panel Replacement - Instrument Panel (I/P) Cluster Lower .
  2. Remove the instrument panel cluster trim plate. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster .
  3. Remove the instrument panel lower extension upper trim panel. Refer to Instrument Panel (I/P) Extension Trim Plate Replacement .
  4. Remove the bolts at the lower edge of the instrument panel driver knee bolster panel.
  5. Pull on the instrument panel driver knee bolster panel in order to disengage the retainers.
  6. Remove the instrument panel driver knee bolster panel from the vehicle.
  7. Inspect the instrument panel driver knee bolster panel for broken or missing retainers.

    Replace the retainers as needed.

Fig 1: Removing Instrument Panel Driver Knee Bolster Panel
G01736564Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals