LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 606 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trim Pad Replacement - Instrument Panel (I/P) Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the instrument panel upper trim pad to the vehicle.
  2. Position the instrument panel upper trim pad to the instrument panel carrier.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the bolts that retain the instrument panel upper trim pad to the instrument panel carrier.

    Tighten 

    Tighten the bolts to 2 N.m (18 in lbs).

  4. Install the nuts that retain the air duct to the instrument panel upper trim pad.

    Tighten 

    Tighten the nuts to 2 N.m (18 in lbs).

  5. Install the instrument panel assist handle. Refer to Instrument Panel (I/P) Assist Handle Replacement .
  6. Install the defroster grille. Refer to Defroster Grille Replacement .
  7. Install the instrument panel passenger knee bolster. Refer to Knee Bolster Replacement - Right .
  8. Install the instrument panel driver knee bolster panel. Refer to Trim Panel Replacement - Knee Bolster .
  9. Install the instrument panel lower extension upper trim panel. Refer to Instrument Panel (I/P) Extension Trim Plate Replacement .
  10. Install the instrument panel cluster trim plate. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster .
  11. Install the instrument panel cluster trim plate filler. Refer to Filler Panel Replacement - Instrument Panel (I/P) Cluster Lower .
scientia non olet · About LEMON Manuals