Initialization Sequence
WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
The EBCM performs one initialization test each ignition cycle. The initialization of the EBCM occurs when the following conditions are met:
- The ignition is ON.
- The bulb check has been completed.
- Vehicle speed is greater than 6 km/h (4 mph).
The initialization sequence briefly cycles each solenoid and the pump motor to verify proper operation of the components. The EBCM sets one or more DTCs in accordance with any malfunction that is detected.
The EBCM defines a drive cycle as the completion of the initialization sequence.