LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 600 (Tires & Wheels) >> Repair Instructions >> Tire Hoist and Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hoist to the crossmember.
    Fig 1: Installing Hoist To Crossmember
    G01686531Courtesy of GENERAL MOTORS CORP.
  2. Install the spare tire shaft and guide to the vehicle.
    Fig 2: Installing Spare Tire Shaft & Guide To Vehicle
    G01686532Courtesy of GENERAL MOTORS CORP.
  3. Install the pin and the retainer clip to the hoist and the shaft.
    Fig 3: Installing Pin & Retainer Clip
    G01686533Courtesy of GENERAL MOTORS CORP.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  4. Install the retaining bolt to the hoist.

    Tighten 

    Tighten the bolt to 20 N.m (15 ft lbs).

  5. Install the spare tire to the hoist.
    Fig 4: Installing Retaining Bolt To Hoist
    G01686534Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals