Refinishing Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: To avoid serious personal injury when applying any two part component paint system, follow the specific precautions provided by the paint manufacturer. Failure to follow these precautions may cause lung irritation and allergic respiratory reaction.

Remove the tire and wheel assembly from the vehicle. Refer to Tire and Wheel Removal and Installation .
Remove the balance weights from the wheel.
Remove the tire from the wheel. Refer to Tire Mounting and Dismounting .
Use a suitable cleaner in order to remove the following contaminants from the wheel:
- Lubricants
- Wax
- Dirt
Important:
- Do not re-machine the wheel.
- Do not use chemicals in order to strip the paint from the wheel.
Use plastic media blasting in order to remove the paint from the wheel.
If the wheel had a machined aluminum finish, spin the wheel and use sand paper in order to restore the circular machined appearance.
Important: The wheel mounting surface and the wheel nut contact surface must remain free of paint.
Mask the wheel mounting surface and the wheel nut contact surface.
Follow the paint manufacturer's instructions for painting the wheel.
Unmask the wheel.
Install a new valve stem.
Important: Use new coated balance weights in order to balance the wheel.
Install the tire to the wheel. Refer to Tire Mounting and Dismounting .
Use a suitable cleaner in order to remove the following contaminants from the wheel mounting surface:
- Corrosion
- Overspray
- Dirt
Install the tire and wheel assembly to the vehicle. Refer to Tire and Wheel Removal and Installation .