LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Power Brake Booster >> Installation

Power Brake Booster: Installation

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the gasket between the power brake booster and the front engine cowl. Install the power brake booster to the front engine cowl.
  2. Install the retaining nuts for the power brake booster to the brake pedal bracket. Tighten the power brake booster retaining nuts to specification. See TORQUE SPECIFICATIONS  .
    3. NOTE: Tighten the power brake booster retaining nuts to the cowl by using the following cross pattern method sequence. Make sure to tighten the nuts evenly before tightening to specifications:
    • Right lower retaining nut.
    • Left upper retaining nut.
    • Left lower retaining nut.
    • Right upper retaining nut.
  3. Recheck the torque after all nuts have been tightened. Install the stoplight switch, the pushrod, and the pushrod retainer to the brake pedal. See STOPLIGHT SWITCH  .
  4. Install the check valve to the power brake booster. Install the vacuum hose to the check valve.
  5. Install the brake master cylinder to the power brake booster. See MASTER CYLINDER  . Bleed the brake system. See BLEEDING, FILLING & FLUSHING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals