LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pipe >> Installation

Brake Pipe: Installation

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Bend the brake pipe to achieve proper fit.
  2. Install the brake pipe to the vehicle. Maintain a clearance of 3/4" (19 mm) for all moving or vibrating components.
  3. Install the brake pipe fasteners to the vehicle.
  4. Connect the brake pipe fittings.
    • Tighten the brake pipe fittings to the BPMV or the wheel jounce hoses to specification. See TORQUE SPECIFICATIONS  .
    • Tighten the brake pipe fittings to the master cylinder to specification. See TORQUE SPECIFICATIONS  .
  5. Bleed the brake hydraulic system. Refer to one of the following procedures:
    • If the brake pipe that was replaced was between the master cylinder and the BPMV, refer to ABS Automated Bleed Procedure in Anti-Lock Brake System.
    • If the brake pipe that was replaced was between the BPMV and the wheel jounce hoses, see BLEEDING, FILLING & FLUSHING BRAKE SYSTEM 
scientia non olet · About LEMON Manuals