LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pads >> Installation (Delco 3486)

Installation (Delco 3486)

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the front brake caliper, bushings, bolts and seals with Delco Silicone Lube GM P/N 18010909 or the equivalent.
  2. Install the front inboard brake pad.
    • Snap the retainer ring into the front brake caliper piston.
    • The front brake pad retainer spring is already staked to the brake pad.
    • The front brake pad must lay flat against the front brake caliper piston.
  3. Install the front outboard brake pad with the wear indicator at the leading edge of the front brake pad during forward wheel rotation. The back of the front brake pad must lay flat against the front brake caliper.
  4. Install the front brake caliper onto the front brake rotor. See FRONT BRAKE CALIPER  . Install the tire and wheel assembly. Tighten to specifications. See TORQUE SPECIFICATIONS  .
    5. NOTE: After lowering, but before moving, the vehicle, pump the brake pedal until the pedal is firm. Check the fluid level in the brake master cylinder after pumping the brakes.
  5. Remove the safety stands. Lower the vehicle.
scientia non olet · About LEMON Manuals